Tools

Race Tech Fork Tube Tool Tftt 01

For use when assembling and disassembling the fork tube from the axle lugs. TOOL FORK TUBE

Race Tech Fork Spring Compressor Tfsc 01

Adapter is recommended for disassembly of Harley-Davidson« cartridge forks Relieves spring pressure for taking off fork tube caps without damaging threads Innovative design allows you to use the tool with forks on or off the bike Simple and fast, saves...

Jims Pinion Gear Locker Tool 2237

Use to lock pinion gear when torquing the pinion gear nut Simple to use; just align underneath gear and screw into case Made in the U.S.A.. PINION GEAR LOCK TOOL

Jims Swingarm Bearing Installer 5822

Both drive side and brake side bearings, which are at different depths, can be easily and accurately installed with this tool kit JIMS« took it one step further and added a remover to press the spacer out of the bearing Made in the U.S.A.. TOOL SWG ARM...

Jims Main Drive Gear Bearing Removal Tool 1720

Removes old bearing straight and will not damage the transmission case Can be used without removing transmission from the bike Made in the U.S.A.. 5SPD MAIN BEAR REMOVR

Moose Racing Clutch Bushing Tool 3909726

For use with all Polaris primary and secondary clutches to remove and replace clutch bushings. TOOL CLUTCH BUSHING POL

Dynojet Clutch Compression Tool For Polaris 79100011

This kit makes compressing or releasing your springs easier than ever Ability to be bolted down Durable and easy to use For Polaris UTV's. CLUTCH COMPRESSION TOOL KIT POLARIS

Jims Reverse Brake Bleeder Tool 738

Innovative method allows for all air to be removed from brake system without having to pump the brake handle or pedal Easy-to-use system pushes new fluid into the brake caliper bleeder up through the master cylinder Works on both single- and dual-disc...

Tecmate Optimate Pro-1 Duo Tm650Us

DUO technology for both 12 V lead-acid and 12.8 V lithium batteries Push button BMS (Battery Management System) reset Smart recovery mode for deep discharged batteries Power supply function to use while tuning or running diagnostic with engine off...

Jims Oil Filter Cutter 935

Use to inspect oil filter for any damaging particles that may be trapped in filter Locks down filter for a clean cut around filter base Fits filters up to 5-1/2" diameter Made in the U.S.A.. TOOL O/FILTER INSP CUTTER

Jims Big Twin Cam Seal Tool 2243

Very simple tool, just mount tool in cover, screw in the two removing screws, turn center, and out comes the cam seal The new seal is then pressed in with the same tool, square and flat for a no leak fit Use to install and remove a cam seal without...

Jims Piston Ring Compressor Set 1236

Fine-tooth ratcheting motion will compress the bands in small increments for accurate compression Will not break or damage rings Made in the U.S.A.. TOOL PISTON RING COMPRESS