JIMS

Jims Cam Bearing And Bushing Alignment Tool 2280

Use to check the alignment of cam bearing to cam cover bushing to within .0003" of centerline Binding of tool indicates misalignment of cam cover and bushing Made in the U.S.A.. CAMBEARING ALIGNMENT...

Jims Cam Bearing Installation Tool 787

Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case Will set bearings .023"-.028" below case surface Use to install the two inner cam...

Jims Cam Bearing Puller 1280

Once the camshafts are removed from the support plate this tool will remove the bearing from the camshaft Removes bearing straight without binding or slipping Made in the U.S.A.. CAM BRG PULLER TWIN...

Jims Cam Bushing Line Reaming Tool 102370

Use to line ream cam cover bushing to size, from inner cam bearing, for a true center line between the two dimensions Finished size will be .0008"-.0015" over the cam journal Made in the U.S.A.. LN...

Jims Cam Chain Tensioner Tool 1283

Designed to unload the pressure on the primary and secondary chain tensioners to assemble and disassemble cams Also checks spring loads on chain tensioners Comes with instructions Made in the U.S.A....

Jims Cam Cover Bushing 2558136

Bushing is made from solid bronze bar stock Machined in one operation with a tolerance of .0002" Features a lead-in for ease of installation Made in the U.S.A.. CAM BUSHING 36-69 BIG TWN

Jims Cam Cover Bushing 2558170

Bushings are made from solid bronze bar stock Machined in one operation with a tolerance of .0002" Feature a lead-in for ease of installation Made in the U.S.A.. CAM BUSHING 70-99 BIG TWN

Jims Cam Cover Bushing 25581705

Bushings are made from solid bronze bar stock Machined in one operation with a tolerance of .0002" Feature a lead-in for ease of installation Made in the U.S.A.. CAM BUSH +.005 70-99 B.T.

Jims Cam Cover Bushing 2558637

Bushings are made from solid bronze bar stock Machined in one operation with a tolerance of .0002" Feature a lead-in for ease of installation Made in the U.S.A.. CAM BUSHING 54-97 XL

Jims Cam Cover Holding Tool 1041Tc

Holds cam cover flat and helps prevent damage/scratches when removing and installing bushings Clamps in vice or BridgeportÖ mill Made in the U.S.A.. CAM CVR HOLD TOOL 70-99BT

Jims Cam Cover O-Ring 2170

Fits most cam covers Made in the U.S.A.. SMALL O-RING ALL CAM CVR

Jims Cam Cover O-Ring 2171

Fits most cam covers Made in the U.S.A.. LARGE O-RING ALL CAM CVR