MOTION PRO

Motion Pro Gear Jammer 80427

Originally developed for removing and installing the primary gear on a Honda CRF450R/X Locks gears in place for easy installation and removal Allows tightening of lock nuts to proper torque setting...

Motion Pro Grip Cutter 80335

Kit includes 6" extension, 1" cutter and 7/8" cutter Perfect for installing hand guards or bar ends Clean cut every time. TOOL GRIP CUTTER

Motion Pro Grip Glue And Multi-Purpose Adhesive 150003

Easy to apply and easy to remove from throttle tube and bars when changing grips High cured temperature resistance is compatible with grip heaters Exceptional bonding to metal, plastic composites,...

Motion Pro Handlebar Stop Start Switch 110113

Model specific handlebar switch for use with Rev2 throttle kit on bikes with ignition and starter switches in stock throttle assembly Extra narrow design is only 26 mm wide Push In/Out engine switch...

Motion Pro Heavy Duty Pin Spanner 80673

Designed for removal and installation of shock reservoirs, screw-in seal heads, fork caps, and bearing retainers Arms span freely pivot a range of 10.5 mm to 150 mm Interchangeable 3 mm, 4 mm, and 5...

Motion Pro Heavy-Duty Clutch Holding Tool 80743

Extended knurled handle provides sure grip when removing or torquing the clutch hub nut Can be used to remove the locking ring on UTV fuel cells to remove fuel pumps Reversible blades work on...

Motion Pro Heim Joint Tool 80434

Handle includes retention O-ring to hold heim joint adapters and heim joint bearing in place Removes and replaces KTM heim joints or aftermarket equivalents Built in stop correctly centers heim joint...

Motion Pro Hex Axle Tool 80397

Use wrench on external hex of tool for situations exceeding 150 lb/ft (EU: 203,37 Nm) 3/8" (EU: 0,95 cm) square drive on both ends rated to 150 lb/ft (EU: 203,37 Nm) Fits internal hex on many late...

Motion Pro Hose Removal Tool 80646

Facilitates removal of fuel and cooling system hoses One end is used to loosen stuck hose, the other end assists in pulling the hose off the fitting Reduces the possibility of damage to hoses and...

Motion Pro Hydraulic Brake Bleeder 80143

Unique check valve lets fluid and air escape while preventing air from re-entering the system Universal tool makes bleeding brakes a one-person job Will not bleed air from a dry system Instructions...

Motion Pro Idle Kit 80045

Kit includes a drill bit, thread tap, two idle screws with lock nuts and instructions Necessary if carburetor top has been replaced with a standard Mikuni cap Install a standard Mikuni idle adjuster...

Motion Pro Ignition System Tester 80122

Will test the ignition systems of most motorcycles, watercraft, ATVs and snowmobiles The larger the gap the spark will jump, the stronger the ignition system Tests the integrity and strength of an...