Tools

Motion Pro Spinner Ii T-Handle With Swivel Drive 80563

Bearing mounted spinner provides faster and easier removal and installation of bolts and nuts Unique two-step drive head offers swivel (rocker) or fixed drive Padded grip handle. TOOL T-HAND SPINNER-2 1/4

Motion Pro Metric Socket T-Handle Set 80145

Hex socket extends only part of the way into the socket to allow the nut to be held flush with the end for easier, hands-free starting Deep sockets allow nuts to be driven over long threaded bolts Slim outside diameter allows sockets to fit in tight...

Motion Pro T-6 Combo Lever Adapter 80327

3/8" (EU: 0,95 cm) drive male and 1/4" (EU: 0,64 cm) drive female for use with sockets for smaller front axles 3/8" (EU: 0,95 cm) square drive is rated for a maximum torque of 90 lb/ft (EU: 122,02 NM) Allows T-6 Combo LeverÖ to be used as a 3/8" (EU:...

Motion Pro T-6 Combo Lever Adapter 80326

3/8" (EU: 0,95 cm) drive male and 1/4" (EU: 0,64 cm) drive female for use with sockets for smaller front axles 3/8" (EU: 0,95 cm) square drive is rated for a maximum torque of 90 lb/ft (EU: 122,02 NM) Allows T-6 Combo LeverÖ to be used as a 3/8" (EU:...

Motion Pro Internal Snap-Ring Pliers 80279

Can be used to remove and replace small to medium internal snap rings up to 50 mm deep, including those used for transmission gear locating, bearing retention, and oil seal retention Allows removal of internal snap rings used in hydraulic master...

Motion Pro Ktm Fork Cap Tool 80290

The tool is slotted to allow removal and replacement of caps with the P/N 11-0081 Micro BleedersÖ This tool allows removal and replacement of the accessory fork cap Versatile design features a 22 mm hex and 3/8" square drive. KTM FORK CAP REMOVER

Motion Pro Flywheel Puller Right Hand Internal Thread With M14 Cap 80372

Used for removal of the flywheel or rotor if applicable Laser etched with Motion Pro logo and part number Heat treated for strength and durability Premium quality high carbon steel Durable hot black oxide finish Right hand thread Comes with M14 cap...

Epi Banding Tool Bdt95

Gives ability to tighten clamp securely and correctly for a proper seal to keep moisture and contaminants out Used to install large or small clamps on EPI CV Boot Kits Ratchet style allows maximum tension. TOOL BANDING CV BOOT

Progressive Suspension Pre-Load Spanner Sw1700

Eliminates the hammer and punch method Easily adjusts single shock pre-load rings Vinyl-dipped handle for sure grip. SHOCK PRE-LOAD WRENCH-ADJ

Dennis Stubblefield Sales Pullers Mp14

Made in the U.S.A.. PULLER 30MM X 1.5

Bikeservice Stud Setter & Extractor Bs4328

Eccentric rotation provides powerful grip for stubborn or rusted threads, or for setting new ones Fits 6 mm - 19 mm studs. STUD REMOVER AND INSTALLR

Muc-Off 5-Piece Brush Set 206

Soft Washing Brush with sintered bristle compound, designed to clean your frame and components while caring for delicate finishes; features a tough, impact resistant handle that won't slip in extreme conditions, an over-sized head for fast cleaning of...