946

Shopping For

Change
Search Reset
  • Daytona Twin Tec Llc Wego Sensor Upgrade Kit 15304

    • Daytona Twin Tec Llc Wego Sensor Upgrade Kit 15304

    DAYTONA TWIN TEC LLC

    $614.38
    (No reviews yet) Write a Review
    SKU:
    1022-0224
    Condition:
    New
    Adding to cart… category.add_cart_announcement

    Product Description

    WEGO IIID dual channel wide-band exhaust gas oxygen sensor interface upgrade kit PART #1022-0224 will log engine data along with the actual air/fuel ratio (AFR); logged AFR data can be analyzed and displayed. Enables or disables settings in the ECM such as ACR (automatic compression release for performing engine compression testing), EITMS, cruise control, and active exhaust, reads and sets engine idle speed rpm Enables or disables settings in the BCM for ignition switch, new radio installation, bank angle sensor for trike installs, program fog light function, ABS installation, and enable service state Activates modules, lights, indicators fuel pump drain and electronic throttle sweep; tests different actuators, light and indicators Includes two analog inputs with 0-20V or +_ 200V range as well as two channel oscilloscope capability for waveform display Data logging automatically triggered when a trouble code is set and shows the data before and after code is set Real-time display of engine sensors along with built-in data logging will store data for up to one hour Latest software will include the latest firmware for easy remote updating of the Twin Scan 4 Communicates with ECM, TSSM and BCM to read, then clear diagnostic trouble codes Requires use of a PC with Windows 7, Windows 8 or Windows 10 for display Programs and reads key fobs, programs PIN and disables security Calibrate speedometer, remove new speedometer display of VinErr Analog inputs can also be used for air/flow ratio (AFR) Easy to navigate software Made in the U.S.A. Not all features are available for all models. Most features are available for almost all models through 2016. For example, the 2017 and newer models have eliminated the adjustability of idle rpm and speedometer calibration for everyone at this time. Models equipped with 12MM oxygen sensors will require 18mm weld nuts be installed in the exhaust system for use with the Twin Scan 3+ kit 18mm oxygen sensors.. SENSOR WEGO UPGRADE KT

    Product Videos

    Custom Field

    Product Reviews

    Write a Review